The video plays back fine, but after a while the program gets killed.
Running top, I observed that after setting the pipeline state to PLAYING,
memory utilisation by the program gradually increases (from 16% to 39%)
before the system cannot handle the playback anymore and just gets killed.
I observed the same memory hogging issue while running the pipeline using
The video file I am using is an AVI file of around 1 hour duration.
[RIFF (little-endian) data, AVI, 288 x 208, ~30 fps, video: DivX 4, audio:
MPEG-1 Layer 3 (stereo, 48000 Hz)]
Any idea on what the possible cause(s) could be - something that I may be
missing out on OR some known issue in freeing memory ?
thanks for the pointer on display blanking in N770.
The display now stays ON for long duration videos without going into power
This message (including attachment if any) is confidential and may be privileged. If you have received this message by mistake please notify the sender by return e-mail and delete this message from your system. Any unauthorized use or dissemination of this message in whole or in part is strictly prohibited.
E-mail may contain viruses. Before opening attachments please check them for viruses and defects. While MindTree Consulting Limited (MindTree) has put in place checks to minimize the risks, MindTree will not be responsible for any viruses or defects or any forwarded attachments emanating either from within MindTree or outside.
Please note that e-mails are susceptible to change and MindTree shall not be liable for any improper, untimely or incomplete transmission.
MindTree reserves the right to monitor and review the content of all messages sent to or from MindTree e-mail address. Messages sent to or from this e-mail address may be stored on the MindTree e-mail system or else where.